Pages

September 06, 2020

15,000 measuring points over 15 millimetres

by Martial Wüthrich, Managing Director, Diavite AG, Switzerland

Always more precise: Modern production processes have to meet ever higher quality requirements. Accordingly, the demands on the measuring technology used to determine the quality of the products are also increasing.

This also applies to the measurement of surface roughness, such as the surface of rolls used in the milling industry. The corresponding measurement devices must meet ever higher demands on accuracy and also be as versatile as possible. In addition, end users of measuring instruments are increasingly demanding special solutions for automated, process-accompanying quality control systems.
 


Wear equals loss

In the milling industry, the condition of the surfaces of the smooth and corrugated rolls is of decisive importance for the profitability of a mill. In modern mills, the roller mills, as the central production unit, run practically around the clock. Since the grinding process is basically purely mechanical - coarse becomes fine by grinding - even modern rollers made of special alloys are subject to a certain amount of wear. Experienced millers know this, and numerous measurements and studies by mill manufacturers prove it: The degree of wear of the rollers has a direct influence on the quality of the products, the yield, the energy consumption, on moisture losses and also on the stability of the grinding process. The bottom line is that the higher the degree of wear, the higher the losses, in tonnes and dollars.

Various control options
These correlations explain the importance of regularly checking the condition of all smooth and corrugated rolls "working" in a mill. These checks can be carried out in various ways. The simplest, but also rather inaccurate, is the visual inspection, where the experienced miller uses a dome to inspect the condition of the rollers. A second possibility is the analysis of the products in the laboratory. This mainly involves determining the particle sizes, moisture loss and/or ash content of the intermediate and end products. Finally, monitoring energy consumption and yield can provide indications of roll wear. The most accurate way to determine roll wear is to measure the surface condition.

Service station or on-site?
The service stations operated by a number of globally active suppliers of milling systems are equipped for such measurements of the surface condition of the grinding rolls. However, this means that the rolls must be removed, replaced by replacement rolls and transported to the service station for inspection and any necessary machining. The whole procedure is very time-consuming and expensive.

The ideal solution is to measure on-site. However, for reliable measurements in the mill, good spatial, hygienic and bright conditions must be available. For the measurement itself, the various suppliers present different measuring equipment. There are two basic types of equipment. One works optically, the other measures tactilely, i.e. "touching".


Read more HERE.
 

The Global Miller
This blog is maintained by The Global Miller staff and is supported by the magazine Milling and Grain
which is published by Perendale Publishers Limited.


For additional daily news from milling around the world: global-milling.com

No comments:

Post a Comment