Pages

November 12, 2020

Bucket elevator inspection

by 4B Components Ltd, USA

Periodic inspections of bucket elevators should be an essential part of any maintenance programme.

Often, it is helpful to conduct these with a trusted vendor who can provide insight into solutions that go beyond just part replacement. The following are examples of common issues found during bucket elevator inspection programs conducted by 4B Components USA. This paper will provide suggestions on what to look for and explain the consequences of each issue.

Issue one: Worn/loose slide lagging
The rubber surface on the head pulley’s slide lagging may wear away, and also laggings can come loose and be in danger of scraping the casing, which can create heat and sparks. In addition, the reduced contact between the pulley surface and the belt can cause the belt to slip under the load, which will also lead to excessive heat. Either of these heat sources could ignite a dust cloud inside the elevator, resulting in an explosion. Finally, if a perforation is worn into the casing dust can escape, and extensive hot work repair will be required.

To help with early indication of these types of issues, the installation of a speed switch on the tail shaft can sound an alarm and provide automatic shutdown before a dangerous belt split condition persists. Also, a correctly positioned misalignment switch can detect

a misaligned belt, a misaligned pulley or a piece of lagging that has come loose. These sensors can alarm or shut down the bucket elevator so that corrective repairs can take place.

Issue two: Broken buckets
No matter the precautions taken, tramp material such as rocks, metal wrenches and wood boards can find their way into bucket elevators. The impact of these foreign objects in the product stream takes a toll and can result in broken buckets. Impact can also knock buckets loose from the belt, diminishing throughput and could potentially cause a plugging situation. Screens and magnets located at the inlet can help capture tramp material before it enters the elevator. Plug sensors can also help to detect a blocked chute. Also, heavier duty elevator buckets with stronger front lips can withstand more impact than lighter duty.


Read more HERE.
 

The Global Miller
This blog is maintained by The Global Miller staff and is supported by the magazine Milling and Grain
which is published by Perendale Publishers Limited.

No comments:

Post a Comment