November 07, 2014

TAPCO - GFMT1404



Tapco was conceived in the early 1970's by Paul D. Taylor, President and Ted W. Beaty, Retired, to fill a void in the elevator bucket industry. At that time, there was only one manufacturer of nonmetallic buckets in the U.S.A. All the other buckets were made from fabricated steel. With the inherent problems of steel buckets and the limited range of the existing polyethylene brand, the time was right for Tapco.

The company has been in its own 92,500 square foot facility for over 25 years. This has allowed us to bring our injection molding "in house" for better control and cost effectiveness. Tapco has nine injection molding machines ranging from a small 150 ton to a very large 1,000 ton press. This allows us to make our entire range of buckets in the most expedient and quality controlled manner.


Tapco stocks the largest inventory of elevator buckets and bolts in the world, some 900,000 buckets and 14 million bolts. We also have the largest inventory of abrasion resistant sheeting, drag flights and hanger bearings in North America.


Read more HERE.
 

The Global Miller
This blog is maintained by The Global Miller staff and is supported by the magazine GFMT
which is published by Perendale Publishers Limited.


For additional daily news from milling around the world: global-milling.com

No comments:

Post a Comment




See our data and privacy policy Click here